Systems Description 2008 :: 2-BSeen LED Safety Brake and Signal System

REDESIGNED AND REENGINEERED

All the special features of the original System:

  • Signal and Brake Lights in one unit
  • 19 Led Lights per side totaling 38 Super Bright Led’s with a life expectancy of up to 10 YEARS!
  • Wrap around designed of Signal Lights with Yellow Leds
  • Rear facing Red Brake Light Leds that are activated by pressing either the Footbrake or Handbrake
  • Mounted on each side of the Handlebars’ at approximately 42 inch’s or higher depending on Handlebars
  • Easily installed into bikes Lighting System

    NEW AND IMPROVED FEATURES:

  • Completely redesigned Mounting Brackets made of Zinc alloy with Rubber bushings and Stainless Steel cap screws
  • Restyled Lens defuses the light more efficiently
  • The Light body is made of the same material used on your bikes existing Signal housings, high impact chrome plated plastic, light weight yet very durable, plus internal Rubber bushings allowing for rotation
  • The Tubes are made from high grade polished and bendable Aluminum
  • Specially designed Piggyback Brake wire making Brake Light installation much easier on most Bikes
  • All Electrical components in the Light Body have been sealed with a protective coating making any moisture a non-issue, this System would work under water! Though not intended for such use
  • Small holes for any moisture to escape have been provided on the bottom of the Light Body


    • 2- Light Systems and Tubes with Rubber Grommets
    2- Mounting Brackets with 4 Stainless Steel Screws
    1- Hex Wrench for Brackets
    2- Nylon Washers for ends of Mirror Shafts
    1- Brake Light Wire with Piggyback Connector
    6- 3M Electrical Taps
    5- Zip Ties | 1- Written Instructions with Photos (not shown)
    Close Window
    2-BSeen Homepage







    2-BSeen Homepage

    Handlebar Mounted Brake & Signal LED Lights
    American Crafted ~ Patent Pending


    THE LED Safety Brake and Signal System Which attaches to Motorcycle Handlebar.

  • SAFETY
  • VISIBILITY
  • CUSTOM MADE
  • HIGH QUALITY
  • GUARANTEED
  • MADE IN USA

    You've Got "To Be Seen".TM


    SAFETY WARNING: “In the multiple vehicle accidents, the driver of the other vehicle violated the motorcycle right-of-way and caused the accident in two-thirds of those accidents. ... “Intersections are the most likely place for the motorcycle accident, with the other vehicle violating the motorcycle right-of-way, and often violating traffic controls. ...

    “The view of the motorcycle or the other vehicle involved in the accident is limited by glare or obstructed by other vehicles in almost half of the multiple vehicle accidents.”*

    * The Hurt report

    High visibility at night is vital to safety. The LED lights are red for brakes and yellow for signal blinker lights. 2-BSeen is mounted on the handlebars of the motorcycle at the level of most car lights. This makes sure that in traffic the oncoming or vehicles behind you can easily see you and your motorcycle. Most accidents are because the car and truck drivers do not know your intentions.

    The LED lights are visible from the front, side and back of the 2-BeSeen brake/signal light. 2BeSeen is the safety accessory designed by a biker for bikers.

    Daytime photographs show the LED lights are an excellent addition. In busy traffic it is great to have your brake and signal lights at eye level. Notice in the SUV photos how 2-BSeen is at the same level as the SUV brake lights. This keeps your intentions equally visible with the many cars, trucks and distractions during daylight driving.

    • 2-BSeen Homepage

    ©2006/7 2-BSeen.com